Instruments and Controls Getting to Know Your Vehicle you must access the on-board diagnos- tic system. With the key switch ON but the engine NOT running, press the throttle pedal to full throttle and release to idle three times. The active fault codes will flash out as described in the Cummins ISB Engine Operation and Maintenance Manual. Contact your dealer or the Cummins engine service center for the explanation of the code. Turn the key switch OFF to exit the diagnostic mode. 18. Coolant Temperature Warning Light This warning light will illuminate and a warning buzzer will sound whenever the engine coolant temperature exceeds the maximum permissible level.
This warning light will illuminate if the water/fuel separator needs to be drained. This warning light will illuminate when an engine problem exists, but the vehi- cle can still be safely driven. The vehi- cle should be serviced to correct the problem but the situation should not be considered an emergency. This warning light will illuminate when a major engine problem exists. It means you should stop and shut down your vehicle as soon as it is safely possible. NOTE: If you need to determine the exact engine problem that turns on warning light 16 or 17, 15. Maintenance - Water in Fuel 16. Check Engine Light 17.
Stop Engine Light This warning light monitors the vehicle anti-lock braking system (ABS). This warning light will illuminate when: the ignition is switched on; the light should extinguish as soon as the vehicle road speed exceeds 5 mph (7 km/h); the vehicle ABS is defective; the conventional braking will remain operative but the vehicle must be driven with care and the ABS must be rectified at the earliest opportu- nity. Also see “Driving” and “Emergency repairs” sections of this handbook. 14. ABS Warning Light