Instruments and Controls Getting to Know Your Vehicle 5. Idle the engine between 1,000 and 1,500 rpm and turn the fan switch to High. 6. After the cab temperature cools to a comfortable level, adjust the fan speed and other controls to keep the desired condition. 7. For efficient air flow in fresh air mode, regularly clean the HVAC fil- ter located on the bottom of the cab. First, place the system in “recirc” mode and then clean the fil- ter with a low pressure air hose. If the air conditioner does not cool the air, have the unit checked at an Authorized Service Center. NOTE:
When the air condi- tioner isn’t in regular use, oper- ate it for at least 15 minutes at least once a month or every 5,000 miles (8,000 km), whichever comes first. This will lubricate the seals in the air conditioning system. side), and the fan (1) to high until the cab becomes cool—adjust as desired. When set to Recirc mode, the air condi- tioning system will automatically shut off fresh air intake and will recirculate cab air. 1. Ensure all heater/air conditioner controls are off. 2. Start the engine. Allow time for warm–up. NOTE: A cold compressor can cause refrigerant to liquefy and warp the valve plates or cause a hydraulic lock. Warm the engine before starting the air conditioner. 3.
Set the air conditioner for maximum cooling. 4. Close all windows. For Efficient Cooling: NOTE: If equipped with optional air conditioning, the air conditioning system is active when the Defrost mode is selected. To defog the windshield: select air dis- tribution to Windshield or between Windshield/Floor and turn the fan speed switch (1) to high. Set the tem- perature control (3) to hot (red position on the control). The air conditioner (if equipped) is automatically activated to remove moisture from the cab. After the windshield is clear, adjust the controls as desired. To cool the cab:
turn on the air condi- tioner (if equipped) (switch 4), set the temperature control (3) to cool (blue Defogging Cooling