PACCAR 270 — 2. Windows and Mirrors—are they clean and adjusted properly?

Daily and Weekly Maintenance CAUTION: Do not tighten belts beyond specified lim- its. Damage to bearings and belts may occur. 3. Fuel Filter/Water Separator Drain- ing—check and drain. Depending on the fuel storage facility, more frequent draining may be required. 4. Windshield washer reservoir fluid level—fill if necessary. Before entering the cab and operating the vehicle, check the following equip- ment for proper maintenance: 1. Lights—do headlights, turn signals, emergency flashers, and exterior lamps function and are they clean and adjusted properly? 2. Windows and Mirrors—are they clean and adjusted properly? Chassis and Cab A belt is considered “used” after 30 min- utes of operation.

After running for an hour or more, new belts will loosen. Check for proper tension after the first period of operation. If the belt can be deflected 1/8 in. (3 mm) more than specified, tighten according to the instructions above. 02953 Retensioning New Belts Tension Test 2. Engine Belt—check tension and condition of belts per engine manu- facturer’s Operation and Mainte- nance Manual. Measure the belt tension at the longest span of the belt. If cracks, breaks or tears are found in any belt, the belt should be replaced before operating the vehicle.

Air conditioner compressor belt (with optional air conditioning only) - The best method of testing belt tension is to apply a good quality commercial gauge. If a tension gauge is not avail- able, use this method of testing: Apply 25 pounds (111 N.) of force midway between the pulleys. Deflection should be one belt thick- ness for each foot distance between the pulley centers.