General Periodical maintenance APPLICATION LUBRICANT * Consult manufacturer or lubricant supplier for special details . Universal Joints EP Drive Shaft Splines CL Wheel Bearings HD Steering Column CL Alternator Bearing BB* Fan Hub BB* Power Steering Reservoir PS Steering Drag Link CL Steering Knuckles CL Clutch Release Bearings BB Brake Shoe Anchor Pins HT Brake Cam Bearings HT Slack Adjusters CL Starter Bearings * CC Turbocharger Aneroid * CC Water Pump BB* Table 3 Lubricant Applications Use Table 4 on page 86 and the list of lubricants below to identify the type of lubricant to use on your vehicle. CC/CD:
Engine oil for severe requirements (MIL–L–2104B /MIL–L– 45199B w/ 1.85% max sulfated ash content) CE: Engine oil meeting severe duty service requirements for direct— injection turbocharged engines. SD: Engine oils with increased protection against temperature deposits, rust, wear, and corrosion. NOTE: The responsibility for meeting these specifi- cations, the quality of the product, and its perfor- mance in service rests with the lubricant supplier. HT: High Temperature grease (Timken Specification 0–616) CD: Engine oil meeting API “Five engine test sequence” CB: Engine oil for mild to moderate requirements PS: Chevron Torque Fluid, Dexron III, or Mercon GL:
Straight mineral gear lubricant, Grade 2 CL: Multipurpose chassis grease EP: Extreme Pressure lubricant Lubrication Types BB: Ball Bearing grease HD: Synthetic SAE 75W90 APPLICATION LUBRICANT Universal Joints EP Drive Shaft Splines CL Wheel Bearings HD Steering Column CL Alternator Bearing BB* Fan Hub BB* Power Steering Reservoir PS Steering Drag Link CL Steering Knuckles CL Clutch Release Bearings BB Brake Shoe Anchor Pins HT Brake Cam Bearings HT Slack Adjusters CL Starter Bearings * CC Turbocharger Aneroid * CC Water Pump BB* *Consult manufacturer or lubricant supplier for special details.