Komatsu — 20 Testing and adjusting

TESTING AND ADJUSTING RELEASING REMAINING PRESSURE IN HYDRAULIC CIRCUIT For PC130-6K 3. Travel motor 1) Disconnect travel motor drain hose (2), then fit a blind plug at the hose end. 2) Fit block under the track shoe grouser, or fit block between the sprocket and frame to lock the track. 3) Start the engine and operate the travel relief with the engine at full throttle. When measuring the oil leakage from the travel motor, mistaken operation of the control lever may lead to a serious accident, so always use signals and check when carrying out this operation. 4) Continue this condition for 30 seconds, then meas- ure the oil leakage for the next one minute.

# When measuring move the motor slightly (to change the position between the valve plate and cylinder, and piston and cylinder), and measure several times. For PC150LGP-6K 3. Travel motor 1) Disconnect drain hose from the travel motor, then fit a blind plug at the hose end. 2) Fit block under the track shoe grouser, or fit block between the sprocket and frame to lock the track. 3) Start the engine and operate the travel relief with the engine at full throttle. When measuring the oil leakage from the travel motor, mistaken operation of the control lever may lead to a serious accident, so always use signals and check when carrying out this operation.

4) Continue this condition for 30 seconds, then meas- ure the oil leakage for the next one minute. # When measuring move the motor slightly (to change the position between the valve plate and cylinder, and piston and cylinder), and measure several times. RELEASING REMAINING PRESSURE IN HYDRAULIC CIRCUIT No accumulator is installed, so the pressure remaining in the piping between the control valve and the hydrau- lic cylinder or swing motor cannot be released by oper- ating the control levers. Therefore, when removing the above piping, be careful of the following points.

1) Run the engine at low idling, operate the hydraulic cylinders so that they are not relieved at the end of the stroke, lower the work equipment to the ground, then stop the engine. # If the engine is stopped with the cylinder relieved at the end of the stroke, wait for 5 – 10 minutes before starting the operation. 2) When removing the piping, gradually loosen the sleeve nut of the piping to slowly release the pres- sure remaining in the piping. Remove the piping when the oil stops spurting out. SM rev. PC130/150LGP-6K 20-48