Engine Assembly (00-02) Camshaft Bearing Support - Installation N14 Page 0-95 The clearance between the bearing support thrust face and the camshaft gear must be 0.20 mm to 0.33 mm [0.008- to 0.013-inch]. After measuring the space between the bearing support and the gear cover flange, add an additional 0.20 mm to 0.33 mm [0.008-inch to 0.013-inch] to that number to determine the thickness of the shims required. Example: Space of 1.52 mm [0.060-inch], measured with a feeler gauge, plus 0.25 mm [0.010-inch] for clearance would require 1.77 mm [0.070-inch] shims. Use a micrometer to measure the shims removed from the support at the time of disassembly.
Add or remove shims as required to obtain the correct clearance be- tween the bearing support and the camshaft gear. Shims are available in the following thicknesses: Shim Thickness mm in 0.05 0.002 0.13 0.005 0.25 0.010 0.63 0.025 Install the required number of shims and a new o-ring on the support bearing.