Cummins — STC ENGINES

Injector and Valve Adjustment Engine Assembly (00-02) N14 Page 0-112 Apply thumb pressure to the tool handle to hold the tappet in the maximum upward position. Caution: An overtightened setting on the injector ad- justing screw will produce increased stress on the in- jector train and the camshaft injector lobe which can result in engine damage. NOTE: Apply enough pressure on the tool handle so that the tappet does not move downward when the 0.56 to 0.68 N•m [5 to 6 in-lb] torque is applied. While holding the tappet up with the tool, use a torque wrench, Part No. 3376592, to tighten the adjusting screw. Torque Value: 0.56 to 0.68 [5 to 6 in-lb] Hold the adjusting screw in this position.

The adjusting screws must not turn when the lock nut is tightened. Tighten the lock nut. Torque Value: 68 [50 ft-lb] Caution: The tappet tool must be removed before ro- tating the crankshaft to prevent damage to the tappet and/or tool. Remove the tappet adjusting tool.