Engine Assembly (00-02) Engine Support Bracket, Front - Installation N14 Page 0-131 Engine Support Bracket, Front - Installation Install the engine support bracket and the eight mounting capscrews. Tighten the capscrews. Torque Value: 68 [50 ft-lb] Vibration Damper - Installation Install two guide pins into the end of the crankshaft. Install the pulley and the vibration damper. NOTE: Make sure the mounting surfaces of the crankshaft nose, the vibration damper, and the pulley are clean, dry, and free of burrs. Caution: Do not use an anti-seize compound, penetrat- ing oil, or oil containing a friction modifier to lubricate the capscrews.
This will result in incorrect capscrew torque and possible capscrew failure. Lubricate the threads of the capscrews and the washer with a film of SAE 15W-40 oil. Install four of the six mounting capscrews. Remove the two guide studs, and install the remaining two capscrews. Install the washers and the capscrews. Keep the crank- shaft from rotating, and tighten the capscrews to the following torque values, in the order shown: SAE Grade No. [ft-lb] 5/8-inch 8 258 [190] Capscrew Size