Cummins — COOLANT FILTER - INSTALLATION

Engine Assembly (00-02) Crankcase Breather Tube - Installation N14 Page 0-147 Crankcase Breather Tube - Installation Install the breather vent tube on the breather tube, and tighten the hose clamps. Torque Value: 4.5 [40 in-lb] Install and tighten the tube support brackets and cap- screws. Torque Value: 47 [35 ft-lb] Lubricating Oil Filter - Installation NOTE: The o-ring can stick on the filter head. Make sure it is removed before installing a new filter. Clean the oil filter head surface. Use clean vegetable oil to lubricate the gasket surface of the filter. Fill the filter with clean 15W-40 oil. Install the filter on the oil filter head.

Tighten the filter until the gasket contacts the filter head surface. Caution: Mechanical overtightening may distort the threads or damage the filter element seal. Use oil filter wrench, Part No. 3375049, to tighten the filter an additional three-fourths to one (3/4 to 1) turn, or follow the instructions supplied with the filter. Coolant Filter - Installation Apply a light film of clean 15W-40 oil to the coolant filter gasket sealing surface before installing the coolant filter. Install the filter as specified by the manufacturer. NOTE: Mechanical overtightening can distort the threads or damage the filter head.