Cummins — CYLINDER BLOCK - SERVICE TOOLS

Cylinder Block Cylinder Block - Service Tools N14 Page 1-3 Cylinder Block - Service Tools The following special tools are recommended to perform procedures in section 1. The use of these tools is shown in the appropriate procedure. These tools can be purchased from your local Cummins Authorized Repair Location. Tool No. Tool Description Tool Illustration Connecting Rod Checking Fixture ST-561 Measure connecting rod bend and twist. Gear Cover Bushing Mandrel Designed to install and remove precision bushings in the gear cover accessory drive bore. ST-598 Dowel Pin Extractor Used to pull dowel pins and crosshead guides. ST-1134 Long Bushing Driver Shaft Use to salvage cylinder blocks.

(Included in cylinder liner count- erbore tool kit, Part No. 3377356.) ST-1168-46 Camshaft Bushing Driver Set Replace cylinder block camshaft bushings. ST-1228 Camshaft Bushing Guide ST-1228-6 Use to install No. 7 bushing.