Cummins — CLEANING

Cylinder Block Camshaft - Cleaning and Inspection (01-17) N14 Page 1-63 NOTE: Oversize bearing shells are available for crankshafts which are 0.25 mm [0.010-inch], 0.51 mm [0.020-inch], 0.76 mm [0.030-inch], or 1.02 mm [0.040-inch] undersize. Bearing shells are identified by steel stamped characters on the back of the bearings to indicate either standard or the amount of oversize. Thrust Bearings - Inspection Visually inspect the thrust bearings for cracks or damage at the locating notch. Measure the thrust bearing thickness. Measure the bear- ings in areas that show visible wear. Thrust Bearing Thickness mm in 6.185 MIN 0.2435 6.312 MAX 0.2485 NOTE:

Thrust bearings are available in 0.25 mm [0.010-inch] and 0.51 mm [0.020-inch] oversize thicknesses. In an assembled engine, the crankshaft end clearance must be 0.10 mm to 0.58 mm [0.004 inch to 0.023-inch]. Refer to Engine Assembly in Procedure 00-02. Camshaft - Cleaning and Inspection (01-17) Cleaning Warning: When using a steam cleaner, wear protective clothing and safety glasses or a face shield. Hot steam can cause serious personal injury. Clean the camshaft with solvent or steam and dry it with compressed air.