Injectors - Cleaning the Exterior and Inspection for Reuse (06-01) Injectors and Fuel Lines N14 Page 6-6 Injectors - Cleaning the Exterior and Inspection for Reuse (06-01) Remove and discard the three injector o-rings. Cleaning - STC Use a clean, lint-free cloth to clean the exterior of the injectors. Use solvent to clean the injector plunger links. NOTE: STC injectors contain a tappet stop link, which is held in place by a plastic retaining clip. Do not immerse or wash the plastic clip in a cleaning solvent because it can dissolve. Cleaning - CELECT™ Use a clean, lint-free cloth to clean the exterior of the injectors. Use solvent to clean the injector plunger links. NOTE:
CELECT™injectors contain a top link which is held in place by a plastic retaining clip. Do not immerse or wash the plastic clip in a cleaning solvent because it can dissolve. Inspection - STC Visually inspect the injector plunger links for damage, excessive wear, and pitting or scoring on the ball ends. NOTE: If the plunger link is damaged or the pitting or scoring can be seen or felt, the plunger links must be replaced.