Cooling System - Service Tools Cooling System N14 Page 8-2 Cooling System - Service Tools The following special tools are recommended to perform procedures in section 8. The use of these tools is shown in the appropriate procedure. These tools can be purchased from your local Cummins Authorized Repair Location. Tool No. Tool Description Tool Illustration Water Pump Bearing Mandrel ST-658 Use to press the water pump bearing on the shaft and to install the bearing and shaft assembly into the water pump body. Bearing Disassembly Fixture Use to hold the bearing spacer when removing the water pump bearings from the shaft.
ST-1114 Thermostat Seat Driver Use to install the seat in the thermostat housing. ST-1225 Rocker Lever Bushing Mandrel Use to press the bearing and spacer assembly into the pulley. ST-1284-1 Pipe Sealant Use when installing pipe plugs or cup plugs on the engine in order to prevent leaks. 3375066 Water Pump Pulley Impeller Puller 3375257 Use to remove the water pump pulley and impeller from the water pump drive shaft.