Water Pump Idler Assembly - Cleaning and Inspection (08-03) Cooling System N14 Page 8-14 Prepare the drive pulley bore surface with Locktite W Primer T, Part No. ST-1272-13. Apply a light film of Locktite W 609, Part No. 3823718, to the bore in the drive pulley. Support the water pump pulley in an arbor press. Push the water pump shaft into the pulley bore until the pulley is against the large diameter (shoulder) of the shaft. Prepare the impeller bore surface with Locktite W Primer T, Part No. ST-1272-13. Apply a light film of Locktite W 609, Part No. 3823718, to the bore in the impeller. Support the pulley end of the water pump shaft in an arbor press.
Push the impeller onto the shaft until the end of the impeller hub is aligned with the end of the shaft. As a final inspection, turn the water pump pulley by hand to inspect the bearings for freedom of rotation. NOTE: If the water pump shaft does not rotate freely in the water pump body, the water pump must be disassembled, inspected, and assembled again. Water Pump Idler Assembly - Cleaning and Inspection (08-03) Cleaning Warning: When using a steam cleaner, wear protective clothing and safety glasses or a face shield. Hot steam can cause serious personal injury. NOTE: Do not apply steam directly to the face of the bearing seal. Use solvent or steam to clean the idler assembly exterior.
Dry with compressed air.