Drive Units Accessory Drive - Cleaning and Inspection for Reuse (09-01) N14 Page 9-5 Accessory Drive - Cleaning and Inspection for Reuse (09-01) Cleaning Remove all gasket material from surfaces (1) and (2). Clean the exterior of the drive with solvent. Dry with com- pressed air. Inspection Measure the drive shaft end clearance at the end of the shaft for accurate measurement. Drive Shaft End Clearance mm in 0.10 MIN 0.004 0.225 MAX 0.009 NOTE: If the shaft end clearance does not meet these spec- ifications, rebuild or replace the drive unit. Refer to Acces- sory Drive - Rebuild (09-02). Visually inspect the housing for cracks or damaged mount- ing holes.
Visually inspect the drive gear (1) for damaged teeth. Visually inspect the shaft (2) for scratches, scoring, or other damage. Accessory Drive - Rebuild (09-02) Disassembly Remove the special capscrew and washer. Caution: Install a 3/8-16 X 3/4-inch capscrew (1) without the washer into the shaft to prevent damage to the shaft while the gear is being removed.