Cummins — INSPECTION

Intake Air System Turbocharger - Cleaning and Inspection (10-01) N14 Page 10-5 Turbocharger - Cleaning and Inspec- tion (10-01) Cleaning Remove all carbon deposits and gasket material from the gasket mating surfaces. NOTE: Tape or plug all openings to prevent solvent or steam from entering the oil cavities in the turbocharger. Warning: When using a steam cleaner, wear protective clothing and safety glasses or a face shield. Hot steam can cause serious personal injury. Use solvent or steam to clean the exterior of the turbo- charger. Dry with compressed air. Remove the tape and the plugs. Inspection Visually inspect the turbocharger housing for damage. Replace if through cracks are found.

Visually inspect the turbine wheel and the compressor impeller for fretting, cracked, or broken vanes. Replace damaged parts. Turn the compressor impeller in the direction shown to inspect the turbine shaft for freedom of rotation NOTE: The shaft must rotate freely. Replace damaged parts. Refer to BHT3C Turbocharger Shop Manual, Bulletin No. 3810230. Cracks on the turbocharger mounting flange longer than 15 mm [0.6-inch] are not acceptable.