Cummins — TURBOCHARGER BEARING RADIAL CLEARANCE - CHECKING

Intake Air System Turbocharger Shaft Axial Clearance - Checking (10-02) N14 Page 10-7 Turbocharger Shaft Axial Clearance - Checking (10-02) Measure the axial clearance (end to end), using dial depth gauge, Part No. ST-537. Set the gauge on zero (0). Push the rotor assembly away from the gauge. Push the rotor assembly toward the gauge and record the clearance. Axial Clearance Model No. mm in BHT3C 0.03 MIN 0.001 0.10 MAX 0.004 Replace the turbocharger if the axial clearance does not meet the specifications. Turbocharger Bearing Radial Clearance - Checking (10-03) Measure the compressor impeller radial clearance. NOTE: Hold the impeller toward the housing.

Install a wire feeler gauge or a flat feeler gauge with a maximum width of 1/4-inch at the minimum clearance point between the im- peller and the housing. Compressor Impeller Radial Clearance Model No. mm in BHT3C 0.15 MIN 0.006 0.457 MAX 0.018 Measure the turbine wheel radial clearance. NOTE: Hold the turbine wheel toward the housing. Install a wire feeler gauge at the minimum clearance point between the wheel and the housing. Turbine Wheel Radial Clearance Model No. mm in BHT3C 0.20 MIN 0.008 0.533 MAX 0.021 NOTE: If the compressor impeller or the turbine wheel to housing radial clearance does not meet the specifications listed, the turbocharger must be rebuilt.

Refer to the Com- ponent Shop Manuals, Bulletin Nos. 3810230 or 3810241, for Holset turbochargers.