Engine Disassembly (00-01) Water Pump - Removal N14 Page 0-23 Water Pump - Removal Remove the six mounting capscrews from the water pump. NOTE: The water pump must be removed carefully to pre- vent damage to the impeller. Remove the water pump from the engine. Remove the water pump out and in a downward direction to clear the dowel pin. This dowel pin, used only on N14 cylinder blocks, prevents the installation of earlier model water pumps which do not incorporate an internal oil cooler coolant return passage. Accessory Drive Pulley - Removal Remove the pulley retaining nut. Caution:
The gear cover will be damaged if the puller capscrews extend beyond the rear face of the accessory drive pulley. Use a standard puller, Part No. ST-647, to remove the pulley. Vibration Damper - Removal Caution: Do not use a hammer or a screwdriver to re- move a viscous damper. These tools can damage the viscous damper. Remove one of the capscrews which holds the vibration damper and the pulley to the crankshaft, and install a guide stud in the hole. Remove the remaining five capscrews, the damper, and the pulley. Engine Support Bracket, Front - Removal Remove the eight mounting capscrews and the front en- gine support bracket from the gear cover.