Cummins — ENGINE RUN-IN PROCEDURE - ENGINE DYNAMOMETER

Engine Run-In Procedure - Engine Dynamometer (14-03) Engine Testing N14 Page 14-24 If the filter cap opening can not be used, remove the fuel supply hose to the gear pump. Lubricate the gear pump gears with clean engine lubri- cating oil. Install the fuel supply hose to the gear pump. Engine Run-In Procedure - Engine Dynamometer (14-03) Measurements from these indicators and gauges must be observed closely during all phases of the engine run-in period. Engine measurements taken are: Engine speed Engine torque Lube oil pressure Coolant out temperature Fuel pressure Crankcase blowby Fuel rate (using Part No.

3376375) To correctly evaluate the engine performance, this ad- ditional measurement, intake manifold pressure (turbo- charger boost), must be observed during engine run-in phases. Refer to the Engine Dynamometer worksheet on the last page of this procedure. NOTE: It is recommended to monitor block coolant pressure during run-in to aid in early indication of a cooling system problem.