Engine Run-In Procedure - Engine Dynamometer (14-03) Engine Testing N14 Page 14-26 Open the throttle to obtain speed at which maximum horsepower is developed and adjust the dynamometer load to achieve 75 percent of rated fuel pressure or 75 percent fuel rate on CELECT™engines. Operate the en- gine at this speed and load level for 3 minutes. Check all gauges and record the data. NOTE: Do not proceed to the next step until blowby is stable within specifications. Maintain maximum horsepower RPM and advertised horsepower, and increase the dynamometer load until 100 percent rated fuel pressure or 100 percent fuel flow is developed.
Operate the engine at this speed and load level for 5 minutes or until the blowby becomes stable within specifications. Check all gauges and record the data. Increase the dynamometer load until the engine speed reduces to the engine’s torque peak RPM. Operate the engine at torque peak RPM for 7 minutes. Check all gauges and record the data. Reduce the dynamometer load until the engine speed increases to the engine’s maximum horsepower RPM. Operate the engine at maximum horsepower RPM for 5 minutes. Check all gauges and record the data. Compare the readings to the specifications listed in the previously mentioned publications.