Cummins — ENGINE RUN-IN PROCEDURE - ENGINE DYNAMOMETER

Dynamometer Worksheet Engine Testing N14 Page 14-28 Dynamometer Worksheet Date Repair Order No. Operator ESN CPL Fuel Pump Code Complaint SC Code (CELECT™) PARAMETER CODE SPECIFICATIONS ACTUAL READING Fuel Pressure (psi @ RPM) Fuel Rate (pph) Check Point 1 (psi @ RPM) (Reference Only) Intake Mfd. Pressure (in.Hg) Governor Break RPM No-Air Setting (psi @ RPM) *Intake Air Restriction 25 in. H 2 0, Maximum Intake Manifold Temperature for CAC Engines 150°F or Below (Target Range) 170°F Maximum *Exhaust Air Restriction 3 in. Hg, Maximum *Fuel Inlet Restriction 8 in. Hg (Dirty Filter), Maximum *Fuel Drain Line Restriction 2.5 in. Hg with Check Valves, Max. 6.5 in. Hg without Check Valves, Max.

Engine Blowby 12 in. H 2 0 New Engines, Max. 18 in. H 2 0 Used Engines, Max. *Recorded at Advertised Horsepower (Maximum Power) Road Speed Limit Engine High Speed Limit Check Oil Level Low High OK Fuel Quality OK Not OK INTAKE MANIFOLD PRESSURE (in. Hg) INTAKE MANIFOLD TEMP. (°F] LUBRICATING OIL PRESSURE (psi) ENGINE SPEED (RPM) *FUEL RATED (pph) FUEL PRESSURE (psi) ENGINE BLOWBY (in.H 2 0) HORSEPOWER OR TORQUE * Be Sure That the Fuel Rate is Corrected for Temperature.

Fuel Temperature Correction for Flow Rate Less than 7°C[45°F] Flow meter not accurate 7 to 13°C[45 to 55°F] Subtract 2% from flow rate reading 13.0 to 20.0°C[55 to 68°F] Subtract 1% from flow rate reading 20.0 to 29°C[68 to 85°F] No Correction 29 to 42°C[85 to 108°F] Add 1% to flow rate reading 42 to 56°C[108 to 132°F] Add 2% to flow rate reading 56°C above [132°F] Flow meter not accurate. Pressure Conversions 1 in. H 2 0 = 0.074 in. Hg = 0.036 psi 1 in. Hg = 13.514 in. H 2 0 = 0.491 psi 1 psi = 2.036 in. Hg = 27.7 in. H 2 0 This Page Can Be Copied For Your Convenience.