Engine Testing Engine Storage - Long Term (14-10) N14 Page 14-47 Remove the intake manifold. Remove the exhaust man- ifold. Refer to Engine Disassembly (00-01). Spray preservative oil into the intake and exhaust ports in the cylinder head and into the exhaust manifolds. Install the intake manifold. Install the exhaust manifold. Refer to Engine Assembly (00-02). Remove the rocker housing cover. Refer to Engine Dis- assembly (00-01). Spray the rocker levers, crossheads, valve springs, valve stems, valve guides, and the push rods with preservative oil. Install the rocker housing cover. Refer to Engine Assem- bly (00-02). Spray preservative oil into the intake port on the air com- pressor.
Brush or spray preservative compound on all of the ex- posed surfaces that are not painted. NOTE: Use a rust preservative compound that meets Mil- itary Specification MIL-C-16137C Type P-2 Grade 1 or 2. Cover all of the openings with heavy paper and tape to prevent dirt and moisture from entering the engine. Install a warning tag on the engine. The tag must indi- cate: The date the engine was treated with preservatives. Do not rotate the crankshaft. The coolant has been drained. Do not operate the engine. Store the engine in an area that is dry and has a constant temperature. Remove the Engine from Long Term Storage Remove the heavy paper and tape from the openings. Remove the warning tag.