Mounting Adaptations - Service Tools Mounting Adaptations N14 Page 16-2 Mounting Adaptations - Service Tools The following special tools are recommended to perform procedures in Group 16. The use of these tools is shown in the appropriate procedure. These tools can be purchased from your local Cummins Authorized Repair Location. Tool No. Tool Description Tool Illustration Dowel Pin Extractor ST-1134 Use to pull dowel pins and crosshead guides. Plate Use in conjunction with drill and ream bushing sets to accurately drill and ream holes in flywheel housings for the installation of standard oversize dowel pins. ST-1232-1 (in Part No.
ST-1232) Spacer Washer Use in conjunction with drill and ream bushing sets to accurately drill and ream holes in flywheel housings for the installation of standard oversize dowel pins. ST-1232-2 (in Part No. ST-1232) Locator Pin Use in conjunction with drill and ream bushing sets to accurately drill and ream holes in flywheel housings for the installation of standard oversize dowel pins. 3375052 (in Part No. ST-1232) Crack Detection Kit This kit provides a convenient way to detect cracks in any engine component. 3375432 Drill/Ream Bushing Set 3376495 Use to drill and ream holes in flywheel housing for the installation of dowel pins.