Cummins — CAPSCREW TORQUE VALUES

Specifications Engine Assembly - Capscrew Torque Values NT 855 Page 18-21 Torque Values Part or Assembly Step ft-lb Water Pump (Big Cam IV and New Big Cam IV) 15 10 30 20 45 35 Note: Tighten the capscrews in the sequence shown. Water Pump (88 Big Cam IV) 15 10 Idler Pulley Support Bracket 30 20 45 35 Note: The two capscrews which mount the idler pulley support bracket are longer than the other four water pump capscrews.

Coolant Transfer Tube Hose Clamp 5 40 in-lb (Big Cam IV and New Big Cam IV Only) Air Compressor Coolant Tubes Tube Nuts 20 15 (Big Cam IV and New Big Cam IV) Air Compressor Air Inlet Fitting Into the Aftercooler 15 10 Air Compressor Air Inlet Tube Hose Clamps 5 40 in-lb (88 Big Cam IV) Water Pump Belt (Big Cam IV and New Big Cam IV) New Belt Tension 710 N 160 lbf Used Belt Tension 290-580 N 65-130 lbf Note: A belt is considered used it if has been in operation for more than 10 minutes. If used belt tension is below the minimum, tighten to the maximum value. Idler Pulley Shaft Lock Nut 70 50 (Big Cam IV and New Big Cam IV)