Cummins — REBUILD SPECIFICATIONS

Specifications Cylinder Block - Rebuild Specifications NT 855 Page 18-29 Part or Assembly Ref.

Point mm in Cylinder Block - Rebuild Specifications Cylinder Block Height 421.87 MIN 16.609 422.45 MAX 16.632 Upper Press Fit Design Counterbore Diameter Standard 166.662 - 166.713 6.5615 - 6.5635 Oversize 167.170 - 167.220 6.5815 - 6.5835 Lower Press Fit Design Counterbore Diameter Standard 166.725 - 166.878 6.5640 - 6.5700 Oversize 167.741 - 167.894 6.6040 - 6.6100 Upper Press Fit Design Upper Liner Bore Diameter Standard 160.096 - 160.197 6.3030 - 6.3070 Oversize None None Lower Press Fit Design Upper Liner Bore Diameter Standard 159.842 - 159.893 6.2930 - 6.2950 Oversize 160.858 - 160.909 6.3330 - 6.3350 Cylinder Liner Lower Bore I.D.

155.54 MIN 6.124 155.60 MAX 6.126 Cylinder Block to Main Bearing Cap Press Fit/Side Clearance Press Fit 0.102 MIN 0.004 Clearance 0.254* MAX 0.010 *Measured between the block and either side of the cap. Main Bearing Bore I.D. 120.612 MIN 4.7485 120.663 MAX 4.7505 Camshaft Bushing I.D. (Installed) 63.457 MIN 2.4983 63.558 MAX 2.5023 Note: If one of the bushings exceeds the maximum specifications, all of the bushings must be replaced.