Cummins — REBUILD SPECIFICATIONS

Specifications Cylinder Block - Rebuild Specifications NT 855 Page 18-31 Part or Assembly Ref. Point mm in Liner O.D. (Lower Press Fit Area) Upper Press Fit Design Standard 159.86 MIN 6.294 159.99 MAX 6.299 .020 Oversize 159.86 MIN 6.294 159.99 MAX 6.299 Liner O.D.

(Lower Press Fit Area) Lower Press Fit Design Standard 159.91 MIN 6.296 159.96 MAX 6.298 .040 Oversize 160.93 MIN 6.336 160.98 MAX 6.338 Cylinder Liner Flange Thickness Upper Press Fit Design Standard 9.01 MIN 0.355 9.04 MAX 0.356 .020 Oversize 9.27 MIN 0.365 9.29 MAX 0.366 Cylinder Liner Flange Thickness Lower Press Fit Design Standard 9.01 MIN 0.355 9.04 MAX 0.356 .040 Oversize 9.52 MIN 0.375 9.55 MAX 0.376 Piston Compression Ring Grooves Width Use piston ring groove wear gauge, Part No. ST-560-6. The piston must be replaced if the widest part of the gauge touches the piston. Piston Oil Ring Groove Width Use a new oil ring and a 0.152 mm [0.006 inch] feeler gauge.

If the feeler gauge enters the oil ring groove without resistance, the piston must be replaced. Piston Skirt Outside Diameter (A) 139.31 MIN 5.485 139.47 MAX 5.491 (B) 139.34 MIN 5.486 139.52 MAX 5.493