Cylinder Block - Rebuild Specifications Specifications Page 18-36 NT 855 Part or Assembly Ref. Point mm in Crankshaft Pulley I.D. 35.05 MIN 1.380 35.10 MAX 1.382 Vibration Damper Thickness Measure the thickness in four places 90 degrees apart approximately 3.18 mm [0.125 inch] from the outside diameter. The difference between any two of the four measurements must not exceed 0.25 mm [0.010 inch]. Accessory Drive Seal Bore I.D. 80.962 MIN 3.1875 81.038 MAX 3.1905 Crankshaft Seal Bore I.D. 120.611 MIN 4.7485 120.688 MAX 4.7515 Accessory Drive Bushing I.D. 39.75 MIN 1.565 39.90 MAX 1.571 Accessory Drive Bushing Bore I.D. 43.07 MIN 1.696 43.10 MAX 1.697