Turbocharger - Inspection Specifications Specifications Page 18-66 NT 855 Part or Assembly Ref. Point mm in Turbocharger - Inspection Specifications Turbocharger Shaft End Clearance Model No. BHT3B/HT3B 0.03 MIN 0.001 0.10 MAX 0.004 BHT4C/HT4B 0.05 MIN 0.002 0.13 MAX 0.005 Turbocharger Compressor Impeller Radial Clearance Model No. BHT3B/HT3B 0.15 MIN 0.006 0.46 MAX 0.018 BHT4C/HT4B 0.15 MIN 0.006 0.46 MAX 0.018 Turbocharger Turbine Wheel Radial Clearance Model No. BHT3B/HT3B 0.20 MIN 0.008 0.53 MAX 0.021 BHT4C/HT4B 0.20 MIN 0.008 0.53 MAX 0.021 Note: Specifications and instructions for rebuilding the turbocharger are provided in the Turbo- charger Component Shop Manuals, Bulletin Nos.
3810230 or 3810241, for Holset turbochargers. Aftercooler Assembly Capscrews Torque Value: 40 [30 ft-lb] Exhaust Manifold Flange To Turbocharger Mounting Stud Torque Torque Value: 40 [30 ft-lb] Note: Apply a coat of anti-seize compound to the threads. Use two mounting nuts locked together to tighten the studs. Air Compressor - Inspection Specifications Single Cylinder Air Compressor Crankshaft End Clearance 0.05 MIN 0.002 0.15 MAX 0.006 Note: Specifications and instructions for rebuilding the single cylinder air compressor are provided in the Air Equipment Rebuild Manual, Bulletin No. 3810242. Two Cylinder Air Compressor Crankshaft End Clearance 0.05 MIN 0.002 0.19 MAX 0.008 Note:
Specifications and instructions for rebuilding the two cylinder air compressor are provided in the Air Equipment Rebuild Manual, Bulletin No. 3810257.