Engine Assembly (00-02) Crankshaft - Installation N14 Page 0-53 The end of the lower main bearing shell opposite the dowel ring must be engaged between the crankshaft and the cylinder block and be seated against the end of the upper bearing shell. NOTE: If installed correctly, the ends of the bearing shells (1) will meet approximately 1.50 mm [0.060-inch] below the cylinder block main bearing mounting surface. NOTE: If used thrust bearings are to be installed, each must be installed in its original location in the engine. The bearing journal numbers must have been marked on the bearing during disassembly. Use clean Lubriplate T 105 or its equivalent to lubricate the lower thrust bearings.
Put the lower thrust bearings around the No. 7 main journal with the grooves facing the thrust surfaces on the crankshaft. NOTE: The notch (1) on the outside diameter of the lower thrust bearings must align with the locating pins in the No. 7 main bearing cap. Use clean 15W-40 oil to lubricate the capscrew threads and the flat washers. Caution: Drain the excess oil from the capscrews before installing them in the cylinder block to prevent hydraulic lock and possible damage to the cylinder block during the capscrew torquing operation.