CAB AND FRAME 2-13 Installation 1. Backlight glass weather strip Fit the backlight weather strip into the backlight glass. At this time, turn the deposit (8) of the weather strip to the right side of the vehicle. Caution: Bring each portion into close contact without any float or corrugation. 2. Backlight glass (6) Set a φ 5 to 6 mm string for installing the window shield into the portion (7) of the backlight weather strip installed on the backlight glass by means of a metal tube of about 8 mm. Adjusting the center of the glass to that of the body, push down the glass with force from the outside and pull the string toward the center of the glass from the inside.
Thus, set the lip into the body flange in succes- sion. N2A0033E 3. Wedge rubber Fit the wedge rubber securely into the bottom end of the backlight glass weather strip. After installing the backlight glass, fill the por- tion (10) in the range of 50 mm up and down (9) of the deposit of the weather strip with sealant. N2A0032E Sealant: CS3061D Caution: Fill the portion B in the specified range with sealant se- curely. Completely remove overflowed sealant.