2-24 CAB AND FRAME Remove the clip on the accelerator pedal side. 9. Instrument Panel assembly Remove the 10 mounting bolts (Wide cab=12 bolts). When the vehicle is provided with an auto air conditioner, remove the solar radiation sensor connector and harness clips from the duct and push the instrument panel assembly (1) from the rear side. N2A0044E 6. Front cover 7. Instrument side grommet Remove the screws and pull out the instrument side grommet. 8. Idling control cable 10. Vent duct Installation N2A0045E Remove the mounting screws. 11. Instrument panel extension For installation, reverse the removal procedure taking the following points into consideration. 1.
After installing each connector, check the opera- tion of each equipment. Remove the mounting screws and clips. 12. Ashtray (driver’s seat side) Pull out the main unit and remove the tray mounting screws. 13. Side defroster nozzle Push out the side defroster nozzle from the rear side of the instrument panel assembly. 14. Fluid tank cover Pull out the fluid tank cover. 15. Relay lid