CAB AND FRAME 2-59 INTERIOR TRIM Front Pillar Trim Cover Removal 1. Front grip (3) Remove the 2 mounting screws. Caution: These screws are coated with Loctite. When removing them, take care not to damage their heads. 2. Front pillar trim cover (1) Remove the one clip at the position (2) and peel off the two-sided adhesive tape at the position (5) shown in the figure. For the high cab or wide cab, remove the clip (4). N2A0097E Installation For installation, reverse the removal procedure taking the following point into consideration. Use a new two-sided adhesive tape and stick it se- curely by press at installation.