CAB AND FRAME 2-83 Rear Mounting (Model without Rubber Bushing) Tighten: Mounting rubber to 50 ± 5.9 N m (5.1 ± 0.6 kg m/36.9 ± 4.4 lb ft) Removal 1. For a tilt vehicle, tilt-up the cab. 2. Cab rear mounting bracket (1) (Tilt cab model) 3. Tighten the cab rear mounting bracket to the spec- ified torque. (Tilt cab model) Remove the nut and pull it up. Cab mounting rear bolt (Non-tilt cab model) Tighten: Cab rear mounting bracket to 88 ± 9.8 N m (9.0 ± 1.0 kg m/ 64.9 ± 7.2 lb ft) Remove the bolt (2) from the cab side bracket (3). 3. mounting rubber (4) 4. Tighten the cab rear mounting bolt to the specified torque. (Non-tilt cab model) Remove the 4 bolts. 4. Cab mounting bracket (5) Tighten:
Cab rear mounting bolt to 88 N m (9.0 kg m/64.9 lb ft) Remove the bolts. (Independent: 5 bolts, Rigid: 4 bolts) N2A0136E Installation For installation, reverse the removal procedure taking the following points into consideration. 1. Tighten the cab mounting bracket to the specified torque. Tighten: Cab mounting bracket to 81 ± 7.8 N m (8.3 ± 0.8 kg m/ 59.7 ± 5.8 lb ft) 2. Tighten the mounting rubber to the specified torque.