1E-100 Electronic control fuel injection system (Common rail type) Fuel temperature (FT) sensor G sensor TSWG0011 TSWG0018 The fuel temperature (FT) sensor is installed onto fuel inlet port of supply pump, and the thermistor changes the resistance according to the temperature. The resistance is low when the fuel temperature is high, and is high when the temperature is low. The engine control module (ECM) energizes the voltage (5 V) to the FT sensor through pull up resistance, and calculates fuel temperature based on change of voltage to use for various controls such as supply pump control etc.
If the resistance is low (temperature is high), the voltage becomes low; if the resistance is high (temperature is low), the voltage becomes high. The G sensor is installed onto supply pump and produces the CMP signal when the cam portion of camshaft passes the sensor. The engine control module (ECM) distinguishes the cylinders by the G signal input from G sensor, determines the crank angle and uses the signal to control fuel injection and calculate the engine speed. These controls is performed, usually based on CKP signal. However it is done by G sensor if the CKP sensor is faulty. Removal Do not replace the G sensor. If it is faulty, replace it as supply pump ASM.
Removal Disconnect the connector and remove it with 19mm-wrench 19mm TSWG0195 TSWG0189