hitachi — Intake system check

1E-160 Electronic control fuel injection system (Common rail type) Intake system check About intake system (If intake system parts are installed by the machine manufacturer, refer to the machine’s manual.) The intake system consists of the air cleaner, intake pipe, turbocharger, etc. Intake air is supplied to the engine through the air cleaner and intake manifold. Step Action Value YES NO 1 Check for excessive dirt or clogging in the air cleaner. Is the trouble detected? — Go to Step 2. Go to Step 3. 2 Clean or replace the air cleaner. Is the procedure completed? — Go to Step 3. — 3 1. Check for crush, breakage, or air leakage in the intake pipe. 2.

Make sure that the intake pipe is a genuine part. • Check for bend or improper piping that may cause increasing in intake air resistance. 3. Check the reed valve for breakage. Is the trouble detected? — Go to Step 4. Go to Step 5. 4 Repair or replace the intake pipe or reed valve. Is the procedure completed? — Go to Step 5. — 5 Check the turbocharger. • Check for abnormal rattling in the turbine shaft. • Check for oil leakage. Note: For work procedure, refer to “Engine section” in the service manual. Is the procedure completed? — Go to Step 6. Go to Step 7. 6 Repair or replace the turbocharger. Note: For work procedure, refer to “Engine section” in the service manual.

Is the procedure completed? — Go to Step 7. — 7 Repair the machine. Is the procedure completed? — Verify repair. —