hitachi — DTC: P0091/P1291 (Flash code 247/248) PCV circuit fault (PCV1 open circuit or GND short circuit / PCV2 open circuit or GND short circuit)

Electronic control fuel injection system (Common rail type) 1E-195 Step Action Value YES NO 5 1. Check for followings in the circuit between PCV and ECM using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Short circuit between terminals • Short circuit to power supply circuit or ignition power supply circuit • Short circuit to other signal circuit 2. If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 12. Go to Step 6. 6 Check the PCV body. 1. Turn the key switch to “OFF”. 2. Remove the harness from the PCV. 3.

Measure the resistance between the PCV connector terminals. Is the resistance specified value? Between terminals: 3.2±0.3 Ω; Each terminal to PCV body: ∞Ω (at normal temperature) Go to Step 8. Go to Step 7. 7 Replace the supply pump (PCV). Note: For work procedure, refer to “Engine section” in the service manual. Is the procedure completed? — Go to Step 12. — 8 Check the DTC again. 1. Connect all the harnesses. 2. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Turn the key switch to “OFF” for more than 10 seconds. 4. Start the engine, and test run with the “Preconditions when DTC is set”. 5.

Check the DTC. Is the DTC P0091/1291detected? — Go to Step 9. Go to “Diagnostic aid”. 9 Is EMPS available? — Go to Step 10. Go to Step 11.