hitachi — DTC: P0112 (Flash code 22) Intake air temperature sensor fault (low voltage fault, GND short, short, short circuit)

Electronic control fuel injection system (Common rail type) 1E-221 Step Action Value YES NO 11 Check the DTC again. 1. Connect all the harnesses. 2. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Turn the key switch to “OFF” for more than 10 seconds. 4. Test run with the “Preconditions when DTC is set”. 5. Check the DTC. Is DTC P0112 detected? — Go to Step 3. Go to Step 12. 12 Check if other DTC is detected. Is other DTC detected? — Go to each DTC diagnosis. Verify repair. 13 1. Start the engine. 2. Check the display of intake air temperature.

Does the display of “Intake air temperature” show error value? 214°C (419°F) (Displayed error value) Go to Step 14. Go to “Diagnostic aid”. 14 Check for installation condition of the IAT sensor, ECM and coupling connector. (Check the IAT sensor circuit for ground short.) 1. Check for play or looseness in the connection. 2. If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 11. Go to Step 15. 15 1. Check for followings in the signal circuit between ECM and IAT sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”.

• Short circuit to IAT sensor ground circuit • Short circuit to ground 2. If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 11. Go to Step 7.