1E-226 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 5 1. Turn the key switch to “OFF”. 2. Disconnect the IAT sensor connector. 3. Short the IAT sensor connector signal terminal to the ground terminal using jump cable. 4. Turn the key switch to “ON”. 5. Check the value for “Intake air temperature sensor” using scan tool. Is the “Intake air temperature sensor” less than the specified value? 0V Go to Step 9. Go to Step 6. 6 1. Check the signal circuit between ECM and IAT sensor for short circuit to the power supply circuit or ignition power supply circuit using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note:
If breaker box is not available, refer to “On- board check procedure for sensors”. Important: If the IAT sensor circuit is shorted to the power supply circuit, the sensor may be broken. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 13. Go to Step 7. 7 1. Check for followings in the signal circuit between ECM and IAT sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance 2. If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 13. Go to Step 8.