hitachi — DTC: P0118 (Flash code 23) Engine coolant temperature sensor input is high (open circuit or short to power supply)

Electronic control fuel injection system (Common rail type) 1E-241 Step Action Value YES NO 8 1. Check for followings in the ground circuit between ECM and ECT sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance 2. If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 13. Go to Step 10. 9 Replace the ECT sensor. Is the procedure completed? — Go to Step 13. — 10 Is EMPS available? — Go to Step 10. Go to Step 11. 11 1. Check the version of ECM software. 2.

Rewrite the software if version upgraded is necessary. Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 13. Go to Step 11. 12 Replace the ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 13. — 13 Check the DTC again. 1.

Connect all the harnesses. 2. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Turn the key switch to “OFF” for more than 10 seconds. 4. Test run with the “Preconditions when DTC is set”. 5. Check the DTC. Is DTC P0118 detected? — Go to Step 2. Go to Step 14.