hitachi — DTC: P0183 (Flash code 211) Fuel temperature sensor fault (high voltage fault, open circuit or short to power supply circuit)

1E-252 Electronic control fuel injection system (Common rail type) DTC: P0183 (Flash code 211) Fuel temperature sensor fault (high voltage fault, open circuit or short to power supply circuit) (*: Specifications vary depending on each machine.

Refer to the machine’s manual.) Engine control module (ECM) Vehicle speed sensor signal SV SV Engine oil pressure sensor signal SV CKP HIGH signal CKP LOW signal Fuel temperature sensor signal Engine coolant temperature sensor signal Vcc 108 E-56 19 E-57 107 E-56 106 E-56 83 E-56 84 E-56 79 E-56 67 E-56 80 E-56 3 H-6 H-20 H-20 H-20 H-20 7 11 10 9 3 H-20 H-20 H-20 2 1 0.75 B/Y 0.75 L/Y 0.75 W/B 0.75 Y/G 0.75 B/Y 0.75 R/B 0.75 B/Y 0.75 B Pulse matching box 2 E-93 1 E-93 1 E-90 2 E-90 1 E-76 E-76 E-76 2 3 0.5 V/W 0.5 Y 2 E-98 1 E-98 Fuel temperature sensor Engine oil pressure sensor Engine coolant temperature sensor 3 E-90 CKP sensor * A CAN HIGH CAN LOW Engine control module (ECM) 0.75 R Vehicle speed sensor 37 E-57 18 E-57 A 4 H-6 Meter CAN HIGH CAN LOW Machine control unit Engine coolant temperature gauge Machine trouble diagnosis monitor TSWG0078 Description of circuit Preconditions when DTC is set The fuel temperature (FT) sensor is the thermistor type and the value of resistance changes according to the temperature.

The fuel temperature (FT) sensor is installed near the fuel inlet duct in the supply pump. The resistance is low when the fuel temperature is high, and is high when the temperature is low. The ECM energizes 5 V to the FT sensor through the pull up resistance, and calculates the fuel temperature from the change in voltage, to utilize for supply control etc. If the resistance is low (temperature is high), the voltage becomes low; if the resistance is high (temperature is low), the voltage becomes high. Key switch input voltage is 16V or more. DTC P1630 or P1633 is not detected. 3 minutes or more has elapsed after starting engine. DTC set condition FT sensor voltage is 4.85 V or more.

Action taken when DTC is set Trouble is displayed on the monitor of the machine or diagnosis lamp comes on. Main trouble symptom Not in particular