hitachi — DTC: P0183 (Flash code 211) Fuel temperature sensor fault (high voltage fault, open circuit or short to power supply circuit)

1E-254 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 5 1. Turn the key switch to “OFF”. 2. Disconnect the FT sensor connector. 3. Short the FT sensor connector signal terminal to the ground terminal using jump cable. 4. Turn the key switch to “ON”. 5. Check the value for “Fuel temperature sensor” using scan tool. Is the “Fuel temperature sensor” less than the specified value? 0V Go to Step 9. Go to Step 6. 6 1. Check the signal circuit between ECM and FT sensor for short circuit to the power supply circuit or ignition power supply circuit using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note:

If breaker box is not available, refer to “On- board check procedure for sensors”. Important: If the FT sensor circuit is shorted to the power supply circuit, the sensor may be broken. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 13. Go to Step 7. 7 1. Check for followings in the signal circuit between ECM and FT sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance 2. If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 13. Go to Step 8.