hitachi — DTC: P0192 (Flash code 245) Common rail pressure sensor fault (low voltage fault, short circuit)

1E-262 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 5 1. Turn the key switch to “OFF”. 2. Disconnect the common rail pressure sensor connector. 3. Turn the key switch to “ON”. 4. Check the value for “Common rail pressure sensor” using scan tool. Is the “Common rail pressure sensor” output voltage specified value? 0V Go to Step 8. Go to Step 6. 6 1. Check for followings in the power supply circuit between ECM and common rail pressure sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance 2.

If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 12. Go to Step 7. 7 1. Check for followings in the signal circuit between ECM and common rail pressure sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Short circuit to common rail pressure sensor ground circuit • Short circuit to ground 2. If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 12. Go to Step 9. 8 Replace the common rail (common rail pressure sensor). Note:

For work procedure, refer to “Engine section” in the service manual. Is the procedure completed? — Go to Step 12. — 9 Is EMPS available? — Go to Step 10. Go to Step 11.