1E-264 Electronic control fuel injection system (Common rail type) About common rail pressure sensor Breaker box inspection procedure Perform the inspection in the following procedure if there is such an instruction to use breaker box in the step. After inspection, return to the diagnostic step. 1 2 3 TSWG0055 Name 1. GND 2. Signal 3. Power supply Name 1. Breaker box 2. DMM Characteristics of common rail pressure sensor (V) 4.2 1 0 200(29008) MPa(psi) TSWG0201 Step Action Value YES NO 15 1. Turn the key switch to “OFF”. 2. Disconnect the common rail pressure sensor connector. 3. Turn the key switch to “ON”. 4.
Connect the DMM between the common rail pressure sensor signal terminal and the ground. Does the DMM indicate the specified value? 0V Go to Step 8. Go to Step 6.