hitachi — DTC: P0193 (Flash code 245) Common rail pressure sensor fault (high voltage fault, open circuit)

1E-266 Electronic control fuel injection system (Common rail type) DTC:

P0193 (Flash code 245) Common rail pressure sensor fault (high voltage fault, open circuit) EGR position sensor signal Common rail pressure sensor signal G sensor signal EGR position sensor signal EGR position sensor signal 5V Engine control module (ECM) B+ B+ B+ 98 E-56 101 E-56 82 E-56 100 E-56 90 E-56 87 E-56 92 E-56 110 E-56 93 E-56 103 E-56 94 E-56 111 E-56 5 H-20 H-20 H-20 H-20 H-20 H-8 H-8 H-8 H-8 H-8 H-8 14 6 13 12 3 7 2 6 1 5 0.5 Br 0.5 L/W 0.75 L 0.75 GY 0.75 W/L 0.75 G/W 0.75 W/B 0.75 G/B 0.75 W/R 0.75 L/W 0.5 L 0.5 L/W 0.75 B/W 0.5 L 0.5 Br 1 E-80 2 E-80 6 E-80 3 E-80 7 E-80 4 E-80 8 E-80 5 E-80 1 E-112 2 E-112 3 E-112 1 E-113 3 E-113 2 E-113 W V U EGR position sensor/EGR motor EGR valve Common rail pressure sensor G sensor TSWG0080 Description of circuit Main trouble symptom The common rail pressure sensor detects the common rail internal pressure.

The common rail pressure sensor is installed to the common rail. As the common rail internal pressure changes depending on engine condition, output voltage of the common rail pressure sensor will change (if the common rail internal fuel pressure is low, output voltage becomes low, if the pressure is high, the output voltage becomes high as well). The engine control module (ECM) reads this output voltage change, converting it into common rail internal pressure, to utilize for control. Dedicated communication circuits are used for the sensor power supply (5V), SIG, and ground in the common rail pressure sensor, which are connected to the ECM.

Also, the sensor circuit is shielded to avoid electrical noise etc. Output lowering Black smoke emitted Engine stall possible Engine hunting Preconditions when DTC is set Key switch input voltage is 16V or more. DTC P1630 or P1635 is not detected. DTC set condition Common rail pressure sensor voltage is 4.5 V or more.