Electronic control fuel injection system (Common rail type) 1E-275 Step Action Value YES NO 1 Perform the OBD system check. Is the procedure completed? — Go to Step 2. Perform “OBD system check”, and Go to Step 2. 2 Check the DTC. 1. Turn the key switch to “OFF” for more than 10 seconds. 2. Start the engine. 3. Check the DTC. Is DTC detected? — Go to Step 3. Go to “Diagnostic aid”. 3 1. Turn the key switch to “OFF”. 2. Remove the coupling connector (H-94) from the cylinder head cover case. 3. Measure the resistance between the coupling connector terminals (power supply terminal — No. 1 cylinder injector drive signal terminal). Is the resistance less than the specified value?
0.45±0.1Ω (20°C {68°F}) Go to Step 4. Go to Step 5. 4 1. Check for followings in the circuit between ECM and coupling connector (H-94) using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 13. Go to Step 8. 5 Check for installation condition of the injector terminal nut. 1. Remove the cylinder head cover. 2. Check the injector terminal nut for looseness etc. 3. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 13. Go to Step 6.
6 Check for installation condition of the coupling connector. 1. Check for play or looseness in the connection. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 13. Go to Step 7.