hitachi — DTC: P0202 (Flash code 272) Open circuit in injection nozzle #2 drive system

Electronic control fuel injection system (Common rail type) 1E-281 Step Action Value YES NO 7 1. Check for following in the circuit between injector terminal and coupling connector. • Open circuit • High resistance 2. If the trouble is detected, repair or replace as required. Is there any trouble in the circuit? — Go to Step 13. Go to Step 9. 8 Check for installation condition of the ECM connector. 1. Turn the key switch to “OFF”. 2. Remove the ECM. 3. Check for play or looseness in the connection. 4. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 13. Go to Step 10. 9 1. Replace the No. 2 cylinder injector. Note:

• For work procedure, refer to “Engine section” in the service manual. • There are two kinds of injectors. Be sure to use the same kind of one which was used before replacement. Is the procedure completed? — Go to Step 13. — 10 Is EMPS available? — Go to Step 11. Go to Step 12. 11 1. Check the version of ECM software. 2. Rewrite the software if version upgraded is necessary. Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed?

— Go to Step 13. Go to Step 12. 12 Replace the ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 13. —