hitachi — DTC: P0205 (Flash code 275) Open circuit in injection nozzle #5 drive system

1E-294 Electronic control fuel injection system (Common rail type) Cylinder No. and injection order Recovery from failure Refer to “List of diagnostic trouble code” and “About recovery from failure” in this section for recovery from failure. 8 1 The conditions to clear the MIL/DTC 2 The present trouble turns to history trouble when the condition is out of the range from DTC set condition (recovery from failure). The diagnosis lamp will go off after the code turns to history trouble and the key switch is turned “OFF” then “ON” again. Using the scan tool, or memory clear switch and diagnostic switch operation enables to clear DTCs.

3 4 7 5 6 Diagnostic aid If the intermittent trouble is suspected, followings may be the cause. Improper connection of harness connector Defective harness routing Worn harness cladding Wire disconnection inside harness cladding Following inspections are necessary to detect these causes. Improper connection of harness connector and ECM connector Poor connection of terminal from connector Unmatched terminals are fitted. Damage of connector lock Poor contact between terminal and wire Damaged harness Visually check the harness for damage. Check the relevant items on the scan tool data display while moving the connector and the harness which are related to the sensor.

The variation of the display indicates the faulty part. TSWG0157 Name 1. Cylinder No. 1 2. Cylinder No. 2 3. Cylinder No. 3 4. Cylinder No. 4 5. Cylinder No. 5 6. Cylinder No. 6 7. Cylinder block 8. Engine front Fuel injection is performed to each cylinder in the order of 1 — 5 — 3 — 6 — 2 — 4. Main trouble symptom Unstable idling Output shortage Preconditions when DTC is set Main relay power supply voltage is 16V or more. 70 rpm or more DTC P0612, P1262, or P0205 is not detected. DTC set condition Open/short circuit is detected in No. 5 cylinder injector drive circuit. No. 5 cylinder injector monitor input signal does not exist for 2.4 seconds or more.

Action taken when DTC is set Trouble is displayed on the monitor of the machine or diagnosis lamp comes on. Back-up mode • Specified back-up value