hitachi — DTC: P0238 (Flash code 32) Boost pressure sensor fault (high voltage fault, short to power supply circuit, ground open circuit)

1E-314 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 5 1. Turn the key switch to “OFF”. 2. Disconnect the boost pressure sensor connector. 3. Turn the key switch to “ON”. 4. Check for “MAP (manifold absolute pressure) sensor” on the data display using scan tool. Is the “MAP (manifold absolute pressure) sensor” less than the specified value? 0.1V Go to Step 8. Go to Step 6. 6 1. Check the signal circuit between ECM and boost pressure sensor for short circuit to the power supply circuit or ignition power supply circuit using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note:

If breaker box is not available, refer to “On- board check procedure for sensors”. Important: If the boost pressure sensor circuit is shorted to the power supply circuit, the sensor may be broken. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 12. Go to Step 7. 7 1. Check for followings in the ground circuit between ECM and boost pressure sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 12. Go to Step 9.

8 Replace the boost pressure sensor. Is the procedure completed? — Go to Step 12. — 9 Is EMPS available? — Go to Step 10. Go to Step 11.