Electronic control fuel injection system (Common rail type) 1E-321 Step Action Value YES NO 4 Check the DTC again. 1. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 2. Turn the key switch to “OFF” for more than 10 seconds. 3. Start the engine, and test run with the “Preconditions when DTC is set”. 4. Check the DTC. Is DTC detected? — Go to Step 5. Go to Step 12. 5 Check the CKP sensor body. 1. Turn the key switch to “OFF”. 2. Remove the harness from the CKP sensor. 3. Measure the resistance between the sensor connector terminals. Is the resistance within the specified value? Between terminals:
108.5 — 142.5Ω; Each terminal — ground: ∞Ω (at normal temperature) Go to Step 6. Go to Step 7. 6 1. Check for followings in the circuit between ECM and CKP sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance • Short circuit to ground • Short circuit between terminals • Short circuit to power supply circuit or ignition power supply circuit 2. If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 11. Go to Step 8. 7 Replace the CKP sensor. Is the procedure completed? — Go to Step 11. — 8 Is EMPS available?
— Go to Step 9. Go to Step 10.