Electronic control fuel injection system (Common rail type) 1E-339 Step Action Value YES NO 6 1. Turn the key switch to “OFF”. 2. Remove the harness from the G sensor. 3. Connect the breaker box or DMM between the G sensor terminals. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. 4. Turn the key switch to “ON”. Is the DMM indication specified value? 0V Go to Step 8. Go to Step 7. 7 1. Check the G sensor circuit for short circuit to other signal circuit using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note:
If breaker box is not available, refer to “On- board check procedure for sensors”. 2. If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 14. Go to Step 9. 8 Replace the G sensor. Is the procedure completed? — Go to Step 14. — 9 1. Visually check the camshaft gear for fault. 2. Check the alignment mark in the timing gear. 3. If the trouble is detected, repair or replace it. Is the trouble detected? — Go to Step 14. Go to Step 10. 10 Replace the supply pump. Note: For work procedure, refer to “Engine section” in the service manual. Is the procedure completed? — Go to Step 11. — 11 Is EMPS available? — Go to Step 12. Go to Step 13.